Installing a Brick Paver Walkway or Big Bricks

The use of Bricks or Pavers to create a pathway or patio area matches a house in a method that is unequaled. In addition, setting up a Brick or Paver pathway does not necessarily require a pro.

The key to setting up a Brick or Paver Walkway is to first properly prepare the location where the bricks/pavers are to be set up. In addition, string lines need to be strung on each side of the walkway.
Once the area has been dug down, 3/4" gravel stone should be laid in and tamped down firmly. The height between the tamped down sand and the stringline ought to equal the thickness of the brick or paver.

Now that you have a stable base, put a 1" pipeline or ledger board the length of the pathway on either side of the pathway. Then utilizing a flatedge, e.g. a 2"x4" board, slide it over the two lengths of the pipe/ledger board. In doing this you will develop a level area to lay the bricks/pavers.

Now location on the level sand/stone dust strips of plastic brick borders. Install a work on both sides of the prepared location. These strips will function as your walkway border and help to maintain the stability and shape of the walkway. You can get these plastic strip borders at the majority of house enhancement shops. The strips ought to be anchored down with 12" galvinized nails. You must sink these nails into the ground and through the strips every foot.

When this is done, you can then begin to lay the bricks/pavers. There are lots of patterns you can lay. I especially like the Herring Bone pattern. The key to laying the bricks/pavers is to make sure that they interlock with each other. Always stagger adjacent rows of bricks by 1/2 of a brick to interlock them. This will again help preserve the stability of the sidewalk.

Inevitably bricks/pavers will require to be cut or split when developing the walkway. Unless you wish to buy more info or lease an expensive wetsaw, I would suggest acquiring an easy brick/paver splitter. It is basically a sculpt with a large end that is the width of the bricks/pavers. To actually cut/split the brick/paver, lay it in a bed of sand and place the chisel at a 75 degree angle over the spot where you want to break the brick. Using a hammer strike the butt end of the sculpt firmly. You may need to do this a couple of times. You may likewise want to turn the brick/paver over and strike the opposite of the brick utilizing the hammer and chisle. Within a couple of strikes the brick/paver need to break cleanly. If your sidewalk has curves you will require to buy/rent a wetsaw.

After installing the bricks, develop the outdoors edges with additional sand, and after that shovel in the topsoil and pack down securely.
Spread stone dust over the new walkway and sweep into the fractures. This will finish the interlocking of the bricks click here and assist to eliminate any weed development.


In addition, setting up a Brick or Paver pathway does not necessarily require a pro. The secret to setting up a Brick or Paver Walkway is to very first effectively prepare the area where the bricks/pavers are to be installed. Now that you have a stable base, position a 1" pipe or journal board the length of the pathway on either side of the sidewalk. These strips will act as your walkway border and help to keep the integrity and shape of the sidewalk. Undoubtedly bricks/pavers will require to be cut or split when building the walkway.

Leave a Reply

Your email address will not be published. Required fields are marked *